Topics: How to do software redundancy for siemens S7 300 Cpu on General Discussion
#1
Start by
Tapan Gangotri
01-04-2014 01:24 AM
How to do software redundancy for siemens S7 300 Cpu
How to do software redundancy for siemens S7 300 Cpu, What are Hardware/sofware requirements? whats are the different blocks we need to configure for using software redundancy.
01-04-2014 03:50 AM
Top #2
Alexandr Bashlak
01-04-2014 03:50 AM
Tapan,
You could find a lot of inforamation of software redundancy by follow link
http://cache.automation.siemens.com/dnl/Tk/TkzOTAyNQAA_1137637_HB/S7_swr_b_en-US.pdf
01-04-2014 06:02 AM
Top #3
nickson zariro
01-04-2014 06:02 AM
thanx for the infor Alex
01-04-2014 08:41 AM
Top #4
Tapan Gangotri
01-04-2014 08:41 AM
i am using step 7 v 5.5 in that i am unable to find fc100 and fb101. kindly help.
01-04-2014 11:39 AM
Top #5
Paolo Dalle Tezze
01-04-2014 11:39 AM
Hi, please pay attention that redundancy in S7-300 series is only software redundancy and switch between cpu it means stop program execution at least for one scan time.
S7-400 series it's the real hot redundancy
---
Posted with Droidin (droidin.net)
01-04-2014 02:06 PM
Top #6
RONEL BOSCH
01-04-2014 02:06 PM
Hi, FYI only: Simation in Gauteng, RSA is an accredited and fully BEE training institute, with specialists offering full time/ short courses only on Siemens PLC, Scada, PCS7, + Siemens VSD and Switchgear, etc. Tel +27118241894
01-04-2014 04:12 PM
Top #7
Ahmad KolahiZonouzi
01-04-2014 04:12 PM
Hi, you need to install software redundancy from Siemens. It will add functions to S7 and graphic template to WinCC. Please refer to the document Mr. Mohammad Balal has mentioned. You may also refer to a short explanation I have given on my site based on my previous expertise I have on this topic, in the following link in "Blog" section. I hope it helps you.
http://www.tolouautomation.com
My best regards,
Zonouzi
01-04-2014 06:29 PM
Top #8
Paul George
01-04-2014 06:29 PM
What is the main difference between S7 300 series and S7 400 series.
which is more good and friendly to use.
please give any suggestion
01-04-2014 09:21 PM
Top #9
Theodoros Tsagkanis
01-04-2014 09:21 PM
where can i find information about motion control?
