Topics: Why is there dip switch inside the Siemens Em 235 CN module? on General Discussion

Start by

Munzir Adnan

01-04-2014 12:30 PM

Why is there dip switch inside the Siemens Em 235 CN module?

Why is there dip switch inside the Siemens Em 235 CN module? How to use this dip switch & how to set this dip switch setting ?thank Ya

01-04-2014 03:03 PM

Top #2

Jason Phin

01-04-2014 03:03 PM

http://support.automation.siemens.com/GB/llisapi.dll?func=cslib.csinfo&lang=en&siteid=csius&aktprim=0&extranet=standard&viewreg=GB&objid=10805149&treeLang=en

This is the link to the Service & Support area of our website that gives you details on the S7200 modules. Page 432 in this manual explains the position of the DIP switch which is used to specify what is the measurement range of you analog inputs.

Regards

01-04-2014 05:21 PM

Top #3

Jason Phin

01-04-2014 05:21 PM

Sorry, the weblink only gets you to the area of manual downloads, look for the one called S7200 System manual.

01-04-2014 07:25 PM

Top #4

Munzir Adnan

01-04-2014 07:25 PM

If I off all the switches present in the dip switch (or in other words change the setting) then what would happen ?

also if i again set back the previous setting then would i get the same result , performance & configuration back ?

Only SW2 is ON other are all OFF

what's this case ?

when it would give +5/-5 Vdc ?

If it gives +5Vdc to the inverter input command then what would happen ? what would be the behavior of the inverter ?

If it gives -5Vdc to the inverter input command then what would happen ? what would be the behavior of the inverter ?

How to check for the defectiveness of the module ?

thanks a lot
GOD bless Ya For eVa

Reply to Thread

Newest posts